JVC GY-DV500U GY-DV500 User Manual - PDF (4,089KB) - Page 46

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING 6-6 Switch Settings of the VCR Section FILTER 1 3200k 2 5600k 3 5600k+ND SHUTTER STATUS MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX PRST A B ON KNEE OFF AUTO BARS CAM HML SAVE STBY VTR GAIN OUTPUT WHT.BAL NG POWER ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 AUDIO CH-2 LEVEL LIGHT ON OFF COUNTER CTL TC UB PRESET/REGEN switch REC/FREE switch CH-1 AUDIO LEVEL CH-2 LITHIUM BATT. CH-1 CH-2 TC GENERATOR AUTO MANUAL PRESET REGEN AUDIO SELECT FREE REC AUDIO INPUT CH-1 CH-2 CONTINUE MENU FRONT REAR GROUP HOLD ITEM SELECT DATA SET SHIFT ADVANCE PRESET Ⅲ Audio input signal selection Use the AUDIO INPUT switch to select whether the sound recorded on audio channel 1 or 2 is the sound from the microphone connector on the front section or the sound from the AUDIO INPUT connector on the rear section.  See page 47. Ⅲ Audio recording level adjustment selection Select "AUTO" or "MANUAL" for the recording level adjustment mode for each audio channel.  See page 48. Ⅲ VCR Setup Menu setting ● REMOTE SELECT Confirm that "LOCAL" is selected if you want to operate on the GY-DV500 only. ● BACK TALLY MODE Select the lightning pattern of the BACK TALLY lamp. ● INPUT SELECT Select the input video signal. To record the GY-DV500's camera image, set to "CAMERA". ● LOW CUT IN For each audio input connector, select whether or not the lower frequency components of the audio signal are cut. Set to this position to eliminate the wind noise of the microphone. ● SAMPLING RATE Select the sampling rate for audio recording (48 kHz or 32 kHz). ● FRONT VOLUME ENABLE Set whether or not the front section's audio volume control should be used. The front section's audio volume control only affects the CH1 audio channel. ● LONG PAUSE TIME Select the time (in minutes) until the GY-DV500 enters the tape protection mode (drum rotation stops) when the recordpause mode is continued for long time. ● SSF MODE Select the mode of the S.S.F. (Super Scene Finder) function. S.S.F. function: Stores the time code of desired scenes or cue points in the unit's memory.  See "S.S.F. function" on page 60. ● DISPLAY SELECT Select the counter display (time code or date/time indication) when the COUNTER switch is set to "TC" or "UB". Ⅲ Setting the time code recording function The GY-DV500 records SMPTE-standard time code during recording. Set the switches according to applications. ● To record a time code as set in the built-in time code generator: • Set the PRESET/REGEN switch to PRESET. • Set the REC/FREE switch. If it is required to record continual time codes across different scenes, set the switch to REC. • VCR Setup Menu setting Select the time code generator's framing mode as drop frame or non-drop using the VCR Setup Menu item No. 416 "NON DROP/DROP". ● To record a time code in continuation of the existing time code on the tape: • Set the PRESET/REGEN switch to REGEN. For details on the time code operations including time code presetting, see "TIME CODE OPERATION" on page 56. 46