JVC GY-DV500U GY-DV500 User Manual - PDF (4,089KB) - Page 51

7. SHOOTING OPERATION 7-1 Basic Recording Operation (Cont'd) 8. 9. 10. VTR trigger button 8. Press the VTR trigger button on the GY-DV500 or lens to start recording. Once recording has started, the BACK TALLY lamp on the rear section of the unit and the tally lamp on the viewfinder light red, and the REC indication in the viewfinder lights green. Note: * The lightning conditions of the BACK TALLY lamp on the rear section of the unit can be changed by setting the VCR Setup Menu item No. 082 BACK TALLY MODE. * The lamp in the viewfinder and on the front section will blink from when the button is pressed and until recording actually starts. 8. TALLY lamp 11. OFF ZEBRA SKIN ON AREA AUTO WHITE ACCU FOCUS VTR AUDIO LEVEL CH-1 TAKE SAVE STBY HML VTR GAIN OUTPUT WHT.BAL NG POWER ON OFF BARS CAM OFF AUTO ON KNEE PRST A B 8. 9. 10. VTR trigger button 12. 9. To stop recording, press the VTR trigger button again. The TALLY lamp and REC indicator lamp go out and the unit enters the record-pause mode. When the VTR trigger button is pressed, the unit enters the record-pause mode after rewinding the tape for about 2 seconds (back-spacing). 10.To restart recording: Press the VTR trigger button on the GY-DV500 or lens. 11.Ending recording: Enter record-pause mode and perform the following operations as required. Ⅲ When it is required to unload the videocassette: • Slide the EJECT switch. Ⅲ When it is required to put the unit in save mode: • Set the VTR switch to SAVE. Drum rotation stops and the GY-DV500 enters the tape protection/power-saving mode. 12.When shooting is completely finished, eject the cassette and set the POWER switch to "OFF". When the unit is not going to be used for a long period, detach the battery pack. About the QUICK REC START Mode BATT REC ALARM 8. If the VTR trigger button is pressed immediately after the videocassette is inserted, the mode becomes the QUICK REC START mode that enables quick start of recording. However, when shooting starts in the middle of the tape, a blank space appears as the new scene will not be linked smoothly with the previous image. Also, the time code does not continue. (Some overlap may also occur.) 8. TALLY lamp Note: ● The unit enters stop mode at tape-end automatically, and if kept longer than 3 or 30 minutes in this mode, SAVE mode is maintained.  See "Menu No. 307: LONG PAUSE TIME" on page 69. ● If the VTR trigger button is pushed very quickly and repeatedly, or the POWER switch is moved immediately after being pressed, the viewfinder REC indicator lamp may blink and the GY-DV500 may not enter the record mode. To remedy this condition set the POWER switch to OFF and wait for 5 seconds or more before turning the power on again. ● A neat transition to the next recorded scene cannot be guaranteed if you end a recording by turning the POWER switch or DC power supply OFF, or by removing the battery pack. ● Before recording a scene that is particularly important, perform test shooting to ensure that normal recording is possible. ● The power consumption can be reduced by setting the LIGHT switch on the display and TALLY lamp to OFF. ● The microphone may pick up the sound of the lens' iris if the iris is changed abruptly or the iris is manually moved abruptly during recording. If you find the noise annoying, please purchase an optional microphone in order to move the microphone away from the lens or ensure that the iris is not changed abruptly during shooting. 51