JVC SR-V10U SR-V10U Instruction manual (1MB, PDF) - Page 36

36 EN C -3 1 2 3 2 4 5 6 7 8 9 0 4 C -3 1 C -3 3 C -3 C -2 C -2 C When programs overlap each other If "PROGRAM NOT COMPLETED PROGRAM OVERLAP" appears, you have another program overlapping the program you have just made. The Program Check screen appears and conflicting programs will start blinking. PROGRAM NOT COMPLETED PROGRAM OVERLAP PR START STOP CH DATE 1 8:00P 11:00 12 12/24 2 10:00A 10:45 40 12/25 3 11:30P 1:00 125 12/25 4 9:00P 10:00 10 12/24 5 6 7 8 (5,∞), THEN ( 3) (PROG.) : END EX. Program 1 (you have just made) and Program 4 overlap each other 1 Confirm overlapping programs Overlapping programs blink on the screen. 2 Select program to modify Press SHUTTLE PLUS %fi, then press SHUTTLE PLUS #. • You can only select one of the overlapping programs. NOTE: If you do not mind this overlap, press PROG. to finish the timer program setting. See "ATTENTION" to the right. Without doing anything for about 1 minute, the VCR will finish the timer programing. TIMER RECORDING (cont.) 3 Cancel or change program setting To cancel a program, press CANCEL when the Program screen you do not want is shown. "PROGRAM COMPLETED" appears on the screen for about 5␣ seconds, then normal screen appears. PROGRAM 4 START STOP 9:00 PM = 10:00PM DATE CH 12/24/00 10 SP SUN PRESS (CANCEL) TO CANCEL PRESS (OK) TO CONFIRM PRESS (PROG.) TO END To change a program, press the appropriate button: START+/-, STOP+/-, DATE+/-, CH+/-, and/or SP/ EP when the Program screen on which you want to make changes is shown, then press OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears. NOTE: If the overlap is not yet solved or another overlap occurs with the timer program setting made last after making correction on a program, the conflicting programs will be shown on the Program Check screen again. Repeat the above steps again until the overlap is solved. ATTENTION If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded. Pattern 1: The program with the lower program number will be recorded. 10:00 Program 1 Program 2 11:00 CH10 CH40 12:00 Not recorded Pattern 2: The program starting earlier will be recorded. 10:00 Program 1 11:00 CH10 Program 2 CH40 12:00 Not recorded Pattern 3: The program starting earlier will be recorded, followed by the remaining portion of the other program. 10:00 Program 1 11:00 CH10 Program 2 12:00 CH40 Not recorded