JVC SR-V10U SR-V10U Instruction manual (1MB, PDF) - Page 50

50 EN TV Brand Setting 2 -1 4 TV TV/VCR 2 -2 POWER 1 2 3 4 5 2 6 2 -3 7 8 9 Number 0 4 1 2 -4 ENTER 3 TV VOL +/- TV CH +/- TV BRAND NAME JVC HITACHI MAGNAVOX MITSUBISHI PANASONIC RCA SHARP SONY SAMSUNG SANYO SEARS TOSHIBA ZENITH BRAND CODE 01, 03 10 02 03 04, 11 05 06 07 12 13 13 08 09 MULTI-BRAND REMOTE CONTROL This Remote can control some functions of remote controllable TVs of the brands listed below. Without setting, you can control a JVC TV. 1 Turn on the TV Turn on the TV using the Power button on the TV or its Remote. 2 Set TV brand code Follow the example shown below. 1 Press and hold TV. 2 Press MBR SET. 3 Press the Number keys to enter your TV's brand code by referring to the table below. 4 Press OK, and release TV. The TV should turn off. If it does, try other operations below. (੬ step 3). ● Once you have set the Remote to operate the TV, you do not have to set it until you replace the batteries from the Remote. ● PANASONIC has two codes. If the TV does not function with one code, try entering the other. 3 Operate TV While holding down TV, press one of the following buttons: POWER, TV/VCR, TV CH +/-, (TV Muting), TV VOL +/-, and Number keys. ● For some brands, you must press ENTER after having pressed the Number keys to enter a channel number. NOTES: ● Depending on the type of TV, some or all functions cannot be operated using this Remote. ● It's not possible to operate a TV not equipped with a remote sensor. (Ex.) To set Remote to RCA 05: MBR SET TV A/B 0 5 ENTER/OSD 3 OK Release Hold down Press in succession