JVC SR-V10U SR-V10U Instruction manual (1MB, PDF) - Page 42

42 EN Satellite Auto Recording REC LINK lamp POWER S VIDEO VIDEO (MONO)L-AUDIO-R REC LINK DIGITAL TBC/NR 4 SP EP VCR A.DUB INSERT PLAY REW - FF + CH- /+ PUSH / TURN 24HR QUICK PROGRAM REC PAUSE STOP/EJECT 1 2 3 2 4 5 6 7 8 9 0 4 1 3 OTHER USEFUL FUNCTIONS (cont.) This function allows you to automatically record a satellite program which is timer-programed on your DBS receiver. Preparation: Connect a DBS receiver to the AUDIO/ VIDEO IN or S VIDEO IN (L-1) connectors* on the rear; otherwise, you cannot use this function. • You can also connect the cable box if it has a timer. * To use these connectors, you have to select which one to use (੬ pg. 40). 1 Set timer program on DBS receiver • For timer programing method, refer to the manual supplied with the DBS receiver. 2 Load a cassette Make sure the record safety tab is intact. 3 Set tape speed Press SP/EP ( ) to set the recording speed. 4 Engage Satellite Auto Recording standby mode Press REC LINK for more than 2 seconds. The VCR turns off automatically and the REC LINK lamp lights (Satellite Auto Recording standby mode). When signals come into the VCR from the DBS receiver, the VCR starts recording (the REC LINK lamp blinks), and stops recording and goes off when signals stop coming in. • To disengage the Satellite Auto Recording standby mode, press REC LINK. The REC LINK lamp goes off. IMPORTANT: Be sure not to turn on the DBS receiver before the program starts broadcasting; otherwise, the VCR will start recording when the DBS receiver is turned on. NOTES: ● While the Satellite Auto Recording standby mode or after Satellite Auto Recording is finished, the VCR will not enter the timer recording standby mode even though "AUTO TIMER" is set to "ON". (੬ pg. 37, 38) ● If you turn off this VCR while Satellite Auto Recording is in progress, recording stops. ● Video Calibration (੬ pg. 38) does not work while Satellite Auto Recording is in progress. ● Auto Clock (੬ pg. 11) does not work while in the Satellite Auto Recording standby mode. ● The VCR may not record a short portion at the beginning of the program or may record slightly longer than the actual length of the program when Satellite Auto Recording method is used. ● If you engage the Satellite Auto Recording standby mode while the DBS receiver is turned on, the VCR will not start Satellite Auto Recording even though the REC LINK lamp blinks. When you turn off and on the DBS receiver once again, the VCR starts recording. ● If you have connected another component other than a DBS receiver (or cable box) to the AUDIO/VIDEO IN or S VIDEO IN (L-1) connectors, be sure not to engage the Satellite Auto Recording standby mode; otherwise, the VCR will start recording when the connected component is turned on. ● Satellite Auto Recording and timer-recording cannot be performed at the same time. ● If the REC LINK lamp does not light but blinks quickly in the Satellite Auto Recording standby mode (even though your DBS receiver is turned off), Satellite Auto Recording will not work properly. If this is the case, perform "Express Timer Programing" (੬ pg. 32) to timer-record a satellite program. (Some DBS receivers output signals even if the power is off. Satellite Auto Recording is not possible with those DBS receivers.)