Lexmark E260dn Service Manual - Page 130
-230, Installation note, Install the two screws holding the new solenoid in place
View all Lexmark E260dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
4513-220, -230 6. Lift and remove the left door mount (C) away from the side frame, and unroute the cable (D) with a spring hook. 7. Reinstall the left door mount, and place the printer on it's top. Note: Be careful to not mar the finish of the printer. 8. Disconnect the cable (D) from J25 on the controller board. Installation note: • Install the two screws holding the new solenoid in place, and route the cable (D) behind the MPF clutch (E). • After disconnecting the old solenoid cable, connect the new solenoid cable to J25 on the controller board. DE C 4-34 Lexmark™ E260d, E260dn
4-34
Lexmark™ E260d, E260dn
4513-220, -230
6.
Lift and remove the left door mount (C) away from the side frame, and unroute the cable (D) with a spring
hook.
7.
Reinstall the left door mount, and place the printer on it’s top.
Note:
Be careful to not mar the finish of the printer.
8.
Disconnect the cable (D) from J25 on the controller board.
Installation note:
•
Install the two screws holding the new solenoid in place, and route the cable (D) behind the MPF clutch
(E).
•
After disconnecting the old solenoid cable, connect the new solenoid cable to J25 on the controller board.
E
C
D