Lexmark Multifunction Laser C77x - Menus and Messages Guide - Page 104

Understanding MFP messages Message Meaning Action Clean scanner glass During a scanner calibration, the firmware detected the scanner ADF or the flatbed (scanner) glass may be dirty. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Touch Restart job if job recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. Close door or insert cartridge The MFP detected the upper front door is open or a toner cartridge is missing. • Close the upper front door. • Install the toner cartridge. Close finisher side door The MFP detected the finisher side door is open. Close the finisher side door to clear the message. Close finisher top cover The MFP detected the finisher top cover is open. Close the finisher top cover to clear the message. Fax Memory Full There is no memory to complete a fax Touch Continue to clear the message. job. Any attempted fax jobs are canceled. If restarting job, replace originals that have not begun to exit the scanner. One or more messages that interrupted a scan job are now cleared. A situation exists where a page is not completely scanned, but not fully exited the ADF. Replace the original documents in the scanner to restart the scan job. Touch Restart job if page level recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Insert staple cartridge The staple cartridge is missing from the MFP. Install a staple cartridge to clear the message. Touch Continue to clear the message and print without using the staple feature. Attendance messages 104