Netgear GSM7312 FSM7326P User Manual - Page 149
config arp retries, General IP Commands, show ip interface
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Default Format l config arp resptime . config arp retries This command configures the ARP count of maximum request for retries. The value for is an integer, which represents the maximum number of request for retries. The range for is an integer between 1-10 retries. Default Format 4 config arp retries General IP Commands show ip interface This command displays all pertinent information about the IP interface. Format IP Address Subnet Mask Routing Mode Administrative Mode Forward Net Directed Broadcasts Active State Link Speed Data Rate MAC Address Maximum Transmission Unit show ip interface A IP address representing the subnet configuration of the router interface. This value was configured into the unit. A mask of the network and host portion of the IP address for the router interface. This value was configured into the unit. The administrative mode of router interface participation. The possible values are enable or disable. This value was configured into the unit. The administrative mode of the specified interface. The possible values of this field are enable or disable. This value was configured into the unit. Displays whether forwarding of network-directed broadcasts is enabled or disabled. This value was configured into the unit. Displays whether the interface is active or inactive. An interface is considered active if its link is up and it is in forwarding state. A integer representing the physical link data rate of the specified interface. This is measured in Megabits per second (Mbps). The burnedin physical address of the specified interface. The format is 6 twodigit hexadecimal numbers that are separated by colons. A number representing the maximum transmission unit (MTU) size (in bytes) for the interface. The default value is 1500. For the standard implementation the Routing Commands 8-7 202-10009-01