Netgear GSM7312 FSM7326P User Manual - Page 75
Management Commands, show network, config network macaddr
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Management Commands These commands manage the switch and show current management settings. show network This command displays network configuration settings that are vital for switch operation. Format IP Address Subnet Mask Default Gateway BurnedIn MAC Address Locally Administered MAC Address MAC Address Type Network Configuration Protocol Current Web Mode Java Mode show network The IP address of the interface. The factory default value is 0.0.0.0 The IP subnet mask for this interface. The factory default value is 0.0.0.0 The default gateway for this IP interface. The factory default value is 0.0.0.0 The burnedin MAC address used for in-band connectivity. If desired, a locally administered MAC address can be configured for in-band connectivity. To take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC address used by this bridge when it must be referred to in a unique fashion. It is recommended that this be the numerically smallest MAC address of all ports that belong to this bridge. However it is only required to be unique. When concatenated with dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning Tree Protocol. Specifies which MAC address should be used for in-band connectivity. The choices are the burnedin or the Locally Administered address. The factory default is to use the burnedin MAC address. Indicates which network protocol is being used. The options are bootp|dhcp|none. Specifies if the switch should allow access from a web browser. Enabled means the switch can be managed from a web browser. The factory default is enabled. Specifies if the switch should allow access to the Java applet in the header frame. Enabled means the applet can be viewed. The factory default is enabled. config network macaddr This command sets locally administered MAC addresses. The following rules apply: • Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally administered (b'1'). Switching Commands 202-10009-01 7-13