Netgear GSM7312 FSM7326P User Manual - Page 82
config snmptrap ipaddr, show trapflags
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software config snmptrap ipaddr This command assigns an IP address to a specified community name. The maximum length of name is 16 case-sensitive alphanumeric characters. Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same IP address, the first entry is retained and processed. All duplicate entries are ignored. Format config snmptrap ipaddr config snmptrap mode This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap receivers are inactive (not able to receive traps). Format config snmptrap mode show trapflags This command displays trap conditions. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to implement the changes. Cold and warm start traps are always generated and cannot be disabled. Format Authentication Flag Link Up/Down Flag Multiple Users Flag Spanning Tree Flag Broadcast Storm Flag show trapflags May be enabled or disabled by selecting the corresponding line on the pulldown entry field. The factory default is enabled. Indicates whether authentication failure traps will be sent. May be enabled or disabled by selecting the corresponding line on the pulldown entry field. The factory default is enabled. Indicates whether link status traps will be sent. Multiple Users Flag. May be enabled or disabled by selecting the corresponding line on the pulldown entry field. The factory default is enabled. Indicates whether a trap will be sent when the same user ID is logged into the switch more than once at the same time (either via telnet or serial port). May be enabled or disabled by selecting the corresponding line on the pulldown entry field. The factory default is enabled. Indicates whether spanning tree traps will be sent. May be enabled or disabled by selecting the corresponding line on the pulldown entry field. The factory default is enabled. Indicates whether broadcast storm traps will be sent. 7-20 202-10009-01 Switching Commands