Netgear GSM7312 FSM7326P User Manual - Page 190
config diffserv class match srcip, Each of these translates into its equivalent port number
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software config diffserv class match srcip This command adds to the specified class definition a match condition based on the source IP address of a packet. The is the name of an existing DiffServ class. The parameter specifies an IP address. The parameter specifies an IP address bit mask; note that although it resembles a standard subnet mask, this bit mask need not be contiguous. The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., match all source IP addresses except for what is specified here). Default Format none config diffserv class match srcip [exclude] config diffserv class match srcl4port keyword This command adds to the specified class definition a match condition based on the source layer 4 port of a packet using a single keyword notation. The is the name of an existing DiffServ class. The value for is one of the supported port name keywords (listed below). The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., match all source layer 4 port numbers except for the one specified here). The currently supported values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number, which is used as both the start and end of a port range. Note: The srcl4port keyword, number, and range commands are alternative ways to specify a source layer 4 port range as a match criterion. Default Format none config diffserv class match srcl4port keyword [exclude] config diffserv class match srcl4port number This command adds to the specified class definition a match condition based on the source layer 4 port of a packet. The is the name of an existing DiffServ class. One layer 4 port number is required. The port number is an integer from 0 to 65535. The optional [exclude] parameter has the effect of negating this match condition for the class (i.e., match all source layer 4 ports except for the one specified here). 9-12 202-10009-01 Differentiated Services