Netgear GSM7312 FSM7326P User Manual - Page 127
show port, show port protocol, Format, slot/port, Admin Mode, Physical Mode, Physical Status
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software show port This command displays port information. Format show port { | all} Mode Privileged EXEC slot/port Type The physical slot and physical port. If not blank, this field indicates that this port is a special type of port. The possible values are: Mon - this port is a monitoring port. Look at the Port Monitoring screens to find out more information. Lag - this port is a member of a port-channel (LAG). Probe - this port is a probe port. Admin Mode Physical Mode Physical Status Link Status Selects the Port control administration state. The port must be enabled in order for it to be allowed into the network. - May be enabled or disabled. The factory default is enabled. Selects the desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode and speed will be set from the auto-negotiation process. Note that the port's maximum capability (full duplex -100M) will be advertised. Otherwise, this object will determine the port's duplex mode and transmission rate. The factory default is Auto. Indicates the port speed and duplex mode. Indicates whether the Link is up or down. Link Trap This object determines whether or not to send a trap when link status changes. The factory default is enabled. LACP Mode Displays whether LACP is enabled or disabled on this port. show port protocol This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated Group. Format show port protocol { | all} Mode Privileged EXEC Switching Commands 202-10009-01_060204 8-61