Netgear GSM7312 FSM7326P User Manual - Page 53
Quick Start up User Account Management, Quick Start up IP Address, Table 6-3. - factory reset
UPC - 606449030693
View all Netgear GSM7312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Quick Start up User Account Management Table 6-3. Quick Start up User Account Management Command Details show users (in Privileged EXEC) show loginsession (in User EXEC) users passwd (in Global Config) copy system:running-config nvram:startup-config (in Privileged EXEC) logout (in User EXEC and Privileged EXEC) Displays all of the users that are allowed to access the switch Access Mode - Shows whether the user is able to change parameters on the switch(Read/Write) or is only able to view then (Read Only). As a factory default, admin has Read/Write access and guest has Read Only access. There can only be one Read/Write user and up to 5 Read Only users. Displays all of the login session information Allows the user to set passwords or change passwords needed to login A prompt will appear after the command is entered requesting the users old password. In the absence of an old password leave the area blank. The operator must press enter to execute the command. The system then prompts the user for a new password then a prompt to confirm the new password. If the new password and the confirmed password match a message will be displayed. User password should not be more than eight characters in length. This will save passwords and all other changes to the device. If you do not save config, all configurations will be lost when a power cycle is performed on the switch or when the switch is reset Logs the user out of the switch Quick Start up IP Address To view the network parameters the operator can access the device by the following three methods. • Simple Network Management Protocol - SNMP • Telnet Quick Start up 6-3 202-10009-01_060204