Netgear GSM7312 FSM7326P User Manual - Page 64

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software the router interface configuration commands. The command prompt at this level is: Command Prompt: $(Interface )# The resulting prompt for the interface configuration command entered in the Global Configuration mode is shown below: $(Config)# interface 2/1 Line Config Mode $(Interface 2/1)# This mode allows the operator to configure the console interface. The operator may configure the interface from the directly connected console or the virtual terminal used with Telnet. The command prompt at this level is: Policy Map Mode Command Prompt: $(Line)# Use the policy-map command to access the QoS policy map configuration mode to configure the QoS policy map. $(Config)# policy-map Policy Class Mode Command Prompt: $(Config policy-map)# Use the "class" command to access the QoS policy- classmap mode to configure the QoS policy map. $(Config-policy-map)# class Class Map Mode Command Prompt: $(Config - policy-classmap)# This mode consists of class creation/deletion and matching commands. The class match commands specify layer 2, layer 3 and general match criteria. Use the class-map commands to access the QoS class map configuration mode to configure QoS class maps. $(Config)# class map Command Prompt: $(Config - class)# Router Config OSPF Mode In this mode, the operator is allowed to access the router OSPF configuration commands. The command prompt at this level is: $(Config)# router ospf Router Config RIP Mode Command Prompt: $(Config-router)# In this mode, the operator is allowed to access the router RIP configuration commands. The command prompt at this level is: $(Config)# router rip Command Prompt: $(Config-router)# DHCP Pool Configuration Mode Use the ip dhcp pool command to access the DHCP Pool Config Mode. 7-6 Mode-based CLI 202-10009-01_060204