Olympus 5060 C-5060 Wide Zoom Reference Manual (9.6 MB) - Page 227
The monitor is hard to see., The viewfinder display is not clear.
View all Olympus 5060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
Troubleshooting 11 Possible cause Corrective action Ref. Page The memory gauge Wait until there is room in the memory gauge. on the monitor is full. P.21 There is a problem with the card. Refer to "Error codes". P.223 The viewfinder display is not clear. The diopter is not adjusted properly. Adjust the diopter so that the AF target mark is clearly visible. P.40 There is condensation* Wait until the camera dries before turning it on - in the viewfinder. again. * Condensation: When it is cold outside, the water vapor in the air is rapidly cooled and turns to droplets of water. Condensation occurs when the camera is suddenly taken from a cold place into a warm room. The monitor is hard to see. The brightness is not Select s in the mode menu and adjust the adjusted properly. brightness. The monitor is exposed to direct sunlight. Position the monitor in the down position or block the sunlight with your hand. P.181 - Vertical lines appear Aiming the camera at a bright subject in sunlight - on the monitor may cause vertical lines to appear on the screen. screen during This is not a malfunction. shooting. The date recorded with the image data is wrong. The date/time is not Set the date/time. The clock adjustment is not set. factory-preset. P.38 The camera has been left with the battery removed. If the camera is left for about 5 days with the battery removed, the date/time setting is canceled. Set the date/time again. P.25, 38 The settings are returned to the factory default settings when the camera is turned off. All Reset is set to ON. Select the SETUP tab in the mode menu and set All Reset to OFF. P.162 Miscellaneous 226