Olympus 5060 C-5060 Wide Zoom Reference Manual (9.6 MB) - Page 228

Troubleshooting Possible cause Corrective action The picture is out of focus. The subject is too close. Position the camera more than 0.2 m/0.7 ft. from the subject and take the picture. To take pictures closer than 0.2 m/0.7 ft., use the super macro mode. Auto focus is not possible. Use manual focus or focus lock to focus on the subject and then shoot. The subject is dark. Turn the AF illuminator on. There is Wait until the camera dries before turning it on condensation* on the again. lens. The monitor goes off. The camera is in the Operate the camera (press the shutter button or sleep mode. the zoom lever). The power is turned off with the monitor is off. If All Reset in the SETUP tab of the mode menu is set to OFF, the camera settings before the power was turned off remain unchanged. Turn on the monitor, and turn off the power. The flash does not fire. The flash is set to the Select a flash mode other than flash off. flash off mode. The subject is illuminated. If you want the flash to fire on a brightly illuminated subject, set the flash to fill-in mode. Sequential shooting The flash does not fire in the sequential shooting (i, j, k, mode. 7) is set. Set o in the DRIVE menu. The camera is in the The flash does not fire in the movie mode. Set a movie mode. different shooting mode. FUNCTION is set to BLACK/WHITE BOARD. The flash does not fire in the BLACK/WHITE BOARD mode. Super macro mode is The flash does not fire in the super macro mode. set. Set the super macro mode to OFF. Panorama mode is set. The flash does not fire in the panorama mode. Cancel the panorama mode. Ref. Page P.103, 104 P.68, 95 P.94 - P.34 P.65, 162 P.74 P.74 P.108 P.70 P.116 P.104 P.111 11 Miscellaneous 227