Philips DVD740VR Owners Manual - Page 10

DVD740VR 4/12/02 12:08 PM Page 10 10 Hookups (cont'd) DVD/VCR to Cable Box/DBS (Satellite Receiver) and TV Using only basic RF coaxial cables This connection will let you use the features of both the VCR and the DVD Player. 1 Cable Signal DVD/VCR ANT-IN ANT-OUT CH3 CH4 RF coaxial cable 2 Cable Box/DBS DVD/VCR IN OUT COMPONENT VIDEO OUT L AUDIO R VIDEO DVD/VCR AUDIO OUT IN L R Y S-VIDEO Cr OUT Cb DIGITAL AUDIO OUT PCM / BITSTREAM COAXIAL OPTICAL OUT RF coaxial cable 75 CAANBTLE/ 3 TV's ANTENNA IN Jack Connections 1 Connect a Cable signal to the DVD/VCR's ANT-IN (Antenna In) Jack. 2 Use an RF coaxial cable (as the one supplied) to connect the ANTOUT (Antenna Out) Jack on the DVD/VCR to the IN Jack on the Cable Box/DBS. 3 Use a second RF coaxial cable to connect the OUT Jack on the Cable Box/DBS to the ANTENNA IN Jack on the TV. Remember... There are two ways to connect your Cable Box/DBS to the DVD/VCR. With the connection on this page: q You may watch one channel while recording another. Follow these steps: 1) Put the Cable Box/DBS on the same channel as the DVD/VCR's CH3/CH4 switch. Set the TV to the Cable Box/DBS output channel (03 or 04). 2) Press OUTPUT SELECT to put the DVD/VCR in VCR mode. The green VIDEO light will appear on the front of the DVD/VCR. Then, press the VCR button, then press VCR/TV to choose VCR position. The green VCR/TV light will appear on the front of the DVD/VCR 3) Press CHANNEL/SKIP j/i (p/o) to select the channel you want to record at the DVD/VCR. Start the recording. 4) Press the VCR/TV button once to put the DVD/VCR in TV position. The VCR/TV light will go off. 5) Select the channel you want to watch at the Cable Box/DBS. q When you play a tape or Disc, make sure the Cable Box/DBS is set to the same channel as the CH3/CH4 switch on the DVD/VCR. Set the TV to the Cable Box/DBS output channel (03 or 04).