TP-Link T1600G-28PS Jetstream Smart Switches User Guide - Page 265

Configuring Layer 2 Multicast MLD Snooping Configuration Port MLD-Snooping Fast-Leave Gi1/0/1 enable enable Gi1/0/2 enable enable Gi1/0/3 enable enable Switch(config-if-range)#end Switch#copy running-config startup-config 3.2.4 Configuring Hosts to Statically Join a Group Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also configure hosts to statically join a group. Follow these steps to configure hosts to statically join a group: Step 1 Step 2 Step 3 Step 4 Step 5 configure Enter global configuration mode. ipv6 mld snooping vlan-config vlan-id-list static ip interface {fastEthernet port-list | gigabitEthernet port-list | ten-gigabitEthernet port-list | port-channel lag-list} vlan-id-list: Specify the ID or the ID list of the VLAN(s). ip: Specify the IP address of the multicast group that the hosts want to join. port-list / lag-list: Specify the ports that is connected to the hosts. These ports will become static member ports of the group. show ipv6 mld snooping groups static Show the static MLD Snooping configuration. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to configure port 1/0/1-3 in VLAN 2 to statically join the multicast group ff80::1234:1: Switch#configure Switch(config)#ipv6 mld snooping vlan-config 2 static ff80::1234:1 interface gigabitEthernet 1/0/1-3 Switch(config)#show ipv6 mld snooping groups static User Guide 240