TP-Link T1600G-28PS Jetstream Smart Switches User Guide - Page 898

Configuring SNMP & RMON Notification Configurations PoE IP-MAC Binding IP Duplicate DHCP Filter ACL Counter 2) Click Apply. Only for products that support PoE. The trap includes the following sub-traps: Over-max-pwr-budget: Triggered when the total power required by the connected PDs exceeds the maximum power the PoE switch can supply. Port-pwr-change: Triggered when a port starts to supply power or stops supplying power. Port-pwr-deny: Triggered when the switch powers off PDs on low-priority PoE ports. The switch powers off them to ensure stable running of the other PDs when the total power required by the connected PDs exceeds the system power limit. Port-pwr-over-30w: Triggered when the power required by the connected PD exceeds 30 watts. Port-pwr-overload: Triggered when the power required by the connected PD exceeds the maximum power the port can supply. Port-short-circuit: Triggered when a short circuit is detected on a port. Thermal-shutdown: Triggered when the PSE chip overheats. The switch will stop supplying power in this case. Triggered in the following two situations: the ARP Inspection feature is enabled and the switch receives an illegal ARP packet; or the IPv4 Source Guard feature is enabled and the switch receives an illegal IP packet. Triggered when the switch detects an IP conflict. Triggered when the DHCPv4 Filter feature is enabled and the switch receives DHCP packets from an illegal DHCP server. Monitors matched ACL information, including the matched ACL ID, rule ID and the number of the matched packets. With both this trap and the Logging feature in the ACL rule settings enabled, the switch will check the matched ACL information every five minutes and send SNMP traps if there is any updated information. 3.2 Using the CLI 3.2.1 Configuring the NMS Host Configure parameters of the NMS host and packet handling mechanism. Step 1 configure Enter Global Configuration Mode. User Guide 873