TP-Link T1600G-28PS Jetstream Smart Switches User Guide - Page 446

Configuring Routing IPv6 Static Routing Configuration Step 1 configure Enter global configuration mode. Step 2 ipv6 routing Enable the IPv6 routing function on the specified Layer 3 interface. Step 3 ipv6 route { ipv6-dest-address } { next-hop-address } [ distance ] Add an IPv6 static route. ipv6-dest-address: Specify the destination IPv6 address of the packets, in the format of X:X:X:X::X/. next-hop-address: Specify the IPv6 gateway address to which the packet should be sent next. distance: Specify the administrative distance, which is a rating of the trustworthiness of the routing information. A higher value means a lower trust rating. When more than one routing protocols have routes to the same destination, only the route that has the shortest distance will be recorded in the IP routing table. The valid values are from 1 to 255 and the default value is 1. Step 4 show ipv6 route [ static | connected ] Verify the IPv6 route entries of the specified type. Step 5 end Return to privileged EXEC mode. Step 6 copy running-config startup-config Save the settings in the configuration file. The following example shows how to create an IPv6 static route with the destination IP address as 3200::/64 and the next-hop address as 3100::1234: Switch#configure Switch(config)#ipv6 route 3200::/64 3100::1234 Switch(config)#show ipv6 route static Codes: C - connected, S - static * - candidate default C 3000::/64 is directly connected, Vlan1 S 3200::/64 [1/0] via 3100::1234, Vlan2 Switch(config)#end Switch#copy running-config startup-config User Guide 421