TP-Link T1600G-28PS Jetstream Smart Switches User Guide - Page 795

Configuring IPv6 IMPB IPv6-MAC Binding Configuration Step 2 Step 3 Step 4 Step 5 ipv6 source binding hostname ipv6-addr mac-addr vlan vlan-id interface { fastEthernet port | gigabitEthernet port | ten-gigabitEthernet port | port-channel port-channel-id } { none | nd-detection | ipv6-verify-source | both } Manually bind the host name, IP address, MAC address, VLAN ID and port number of the host, and configure the protect type for the host. hostname: Specify a name for the host. It contains 20 characters at most. ipv6-addr: Enter the IPv6 address of the host. mac-addr: Enter the MAC address of the host, in the format of xx:xx:xx:xx:xx:xx. vlan-id: Enter the VLAN ID of the host. port: Enter the number of the port on which the host is connected. none | nd-detection | ipv6-verify-source | both: Specify the protect type for the entry. None indicates this entry will not be applied to any feature; nd-detection indicates this entry will be applied to ND Detection; ipv6-verify-source indicates this entry will be applied to IP Source Guard; both indicates this entry will be applied to both ND Detection and IP Source Guard. show ip source binding Verify the binding entry. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to bind an entry with the hostname host1, IPv6 address 2001:0:9d38:90d5::34, MAC address AA-BB-CC-DD-EE-FF, VLAN ID 10, port number 1/0/5, and enable this entry for ND Detection. Switch#configure Switch(config)#ipv6 source binding host1 2001:0:9d38:90d5::34 aa:bb:cc:dd:ee:ff vlan 10 interface gigabitEthernet 1/0/5 nd-detection Switch(config)#show ipv6 source binding U Host IP-Addr MAC-Addr VID Port ACL Source -------- --- ---- --- ------ 1 host1 2001:0:9d38:90d5::34 aa:bb:cc:dd:ee:ff 10 Gi1/0/5 ND-D Manual Switch(config)#end Switch#copy running-config startup-config User Guide 770