TP-Link T1600G-28PS Jetstream Smart Switches User Guide - Page 53

Managing System System Info Configurations Get Time from NTP Server Synchronize with PC's Clock 2) Click Apply. Get the system time from an NTP server. Make sure the NTP server is accessible on your network. If the NTP server is on the internet, connect the switch to the internet first. Time Zone: Select your local time zone. Primary Server: Enter the IP Address of the primary NTP server. Secondary Server: Enter the IP Address of the secondary NTP server. Once the primary NTP server is down, the EAP can get the system time from the secondary NTP server. Update Rate: Specify the interval the switch fetching time from NTP server, which ranges from 1 to 24 hours. Synchronize the system time with the clock of your currently logged-in host. 2.1.4 Configuring the Daylight Saving Time Choose the menu SYSTEM > System Info > Daylight Saving Time to load the following page. Figure 2-7 Configuring the Daylight Saving Time Follow these steps to configure Daylight Saving Time: 1) In the DST Config section, enable the Daylight Saving Time function. 2) Choose one method to set the Daylight Saving Time and specify the related parameters. Predefined Mode If you select Predefined Mode, choose a predefined DST schedule for the switch. USA: Select the Daylight Saving Time of the USA. It is from 2: 00 a.m. on the Second Sunday in March to 2:00 a.m. on the First Sunday in November. Australia: Select the Daylight Saving Time of Australia. It is from 2:00 a.m. on the First Sunday in October to 3:00 a.m. on the First Sunday in April. Europe: Select the Daylight Saving Time of Europe. It is from 1: 00 a.m. on the Last Sunday in March to 1:00 a.m. on the Last Sunday in October. New Zealand: Select the Daylight Saving Time of New Zealand. It is from 2: 00 a.m. on the Last Sunday in September to 3:00 a.m. on the First Sunday in April. User Guide 28