TP-Link TD-W8960N User Guide - Page 28
Enable Fullcone NAT, PPPoE Service Name - mtu
UPC - 845973060343
View all TP-Link TD-W8960N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
TD-W8960N Wireless N ADSL2+ Modem Router User Guide 4. Enter the following parameters and then click Next. Figure 4-10 ¾ PPP Username/Password: Enter the User Name and Password provided by your ISP. These fields are case-sensitive. ¾ PPPoE Service Name: Enter the Service Name if it was provided by your ISP. If you leave it blank, the default name will be the same as the Service Description on the previous screen. ¾ Authentication Method: Select the Authentication Method from the drop-down list, the default method is AUTO, and you can leave it as a default setting. ) Note: If you are not sure about the PPP IP extension and PPP Debug Mode etc. below, please don't select these options. ¾ MTU Size: Maximum Transmission Unit Size. Check this box then you can change the MTU size. The default MTU value is 1480 Bytes. It is not recommended that you change the default value unless required by your ISP. ¾ Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act. ¾ Dial on demand (with idle timeout timer): The Router will cut off the Internet connection after it has been inactive for a specific period of time (idle timeout), and it will automatically re-establish the connection as soon as you attempt to access the Internet again. If your Internet is charged by time you may want to select this option in order to save money. ¾ PPP IP extension: Select this option to get the public IP address from the PPP server to your 21