Xerox 5500/YB User Guide - Page 219

Front Panel Messages Error or Warning Messages (Continued) Message Out Of Paper Load Tray [1 (MPT) | 2 | 3 | 4 | 5 | 6] with [size*] [type*] Paper Not Available Load Tray [1 (MPT) | 2 | 3 | 4 | 5 | 6] with [size*] [type*] Paper Size Jam Tray [1 (MPT) | 2 | 3 | 4 | 5 | 6] Check Paper Tray Guides And Open Door A to Clear Jam Paper Size Jam Tray [1 (MPT) | 2 | 3 | 4 | 5 | 6] Check Size And Open Door A To Clear Punch Failure Punch Waste Box is Full, Unload It Punch Waste Box is Missing Description Load the indicated paper size and type into the indicated tray. Replace the paper in the indicated tray with paper of the indicated size and type; or select Print with Available Paper to use a paper size and type currently in the printer. Warning - Use caution, some components inside Door A may be hot. 1. Confirm that the paper guides in the specified tray are pressed against the paper. 2. Open Door A. 3. Remove the jammed paper. 4. Close Door A. Warning - Use caution, some components inside Door A may be hot. 1. Confirm that the paper guides in the specified tray are pressed against the paper. 2. Select Printer Setup, Paper Handling Setup, Tray(n) Setup. 3. Confirm that the paper size selected in the menu matches the paper size loaded in the tray. 4. Open Door A. 5. Remove the jammed paper. 6. Close Door A. An error was detected in the Punch. Printing continues without punching 1. Turn power off. 2. Verify Finisher wire harnesses are properly connected by unplugging and reconnecting. 3. Turn power on 4. If error continues, call Service. Remove the contents from the punch waste box to continue printing punched jobs. Printing continues without punching. 1. Open Door G. 2. Pull out the punch waste box R4 and discard its contents. 3. Reinsert the punch waste box. 4. Close Door G. Reinsert the punch waste box to continue printing punched jobs. Printing continues without punching. 1. Open Door G. 2. Reinsert the punch waste box R4. 3. Close Door G. Phaser® 5500 Laser Printer 4-66