Yamaha EL-87 Owner's Manual - Page 71
Resetting the Electone to the Factory Preset Power On Reset
View all Yamaha EL-87 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Registration numbers cannot be entered beyond the the Registration Shift function's capacity of 80. The following message momentarily appears when the 80 spaces have been filled: First delete unnecessary registrations, then perform the operation again. Resetting the Electone to the Factory Preset (Power On Reset) All current settings including Registration Memories, User voices and User rhythms can be deleted at once by using the Power On Reset function. To reset the all settings: 1 Turn off the power. 2 While holding down the top left Data Control button, turn the power back on. Be careful when using this operation, since it erases all your existing data. Always save your important data to a floppy disk using M.D.R. (see page 68) in advance. Turning the Electone off erases all panel settings you have made. When the Electone is turned on, Basic Registration 1 is automatically selected. If you have made panel settings you wish to keep, save them to Registration Memory before turning the Electone off. You can, however, restore the panel settings that were made before the Electone was last turned off. In doing this, first be careful NOT to press any panel buttons (excepting those in Basic Registration) after you turn the Electone back on. Then, to restore the previous settings, hold down the M (Memory) button and press D (Disable) button. 67