Yamaha RX V659 MCXSP10 Manual - Page 121

After Auto Setup, W-1:out Of Phase, W-2:over 24m 80ft, W-3:level Error

Page 121 highlights

After AUTO SETUP TROUBLESHOOTING Warning message Cause Remedy W-1:OUT OF PHASE W-2:OVER 24m (80ft) W-3:LEVEL ERROR Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. The distance between the speaker and the listening position is over 24 m (80 ft). The difference of volume level among speakers is excessive. (No level correction is made.) Check the speaker connections for proper polarity (+ or -). Bring the speaker closer to the listening position. Readjust the speaker installation so that all speakers are set in locations with similar conditions. Check the speaker connections. Use speakers of similar quality. Adjust the output volume of the subwoofer. Notes • If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again. • If warning "W-1" appears, corrections are made, but they may not be optimal. • If warning "W-2" or "W-3" appears, no corrections are made. • If error "E-10" occurs repeatedly, please contact a qualified YAMAHA service center. See page 13 - - 13 - 33 ADDITIONAL INFORMATION 117

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132

117
TROUBLESHOOTING
ADDITIONAL
INFORMATION
After AUTO SETUP
If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
If warning “W-1” appears, corrections are made, but they may not be optimal.
If warning “W-2” or “W-3” appears, no corrections are made.
If error “E-10” occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message
Cause
Remedy
See
page
W-1:OUT OF PHASE
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
13
W-2:OVER 24m (80ft)
The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
W-3:LEVEL ERROR
The difference of volume level among
speakers is excessive. (No level correction
is made.)
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
13
Use speakers of similar quality.
Adjust the output volume of the subwoofer.
33
Notes