Yamaha RXV1065 Owner's Manual - Page 24

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Optimizing the speaker setting for your listening room (YPAO) When an error message is displayed during measurement If an error is detected during measurement, the measurement is canceled and "Error" appears on the GUI screen. Check the error and solve the problem. For details on each error message, see page 75. Press jCursor n once, press jCursor l / h to select "Retry" or "Exit" and then press jENTER. Error E-1 : No Front Speakers FrontL/R channel signals are not detected. Check wiring and connections of the front L/R speakers. Retry Exit Move focus Retry Performs "Auto Setup" again. Exit Terminates the measurement and "Auto Setup". y • When "E-5:NOISY" appears, you can continue measurement. To continue measurement, select "Proceed". However, we recommend that you solve the problem first and then perform measurement again. When a warning message is displayed after measurement If a problem occurs during measurement, "Check xx warning(s)" appears on the GUI screen. Check the warning and solve the problem. For details on each warning message, see page 76. Auto Setup Result Speaker Config : 3 /4 / 0.1 Distance (Min / Max) : 8.0ft / 8.5ft Level (Min / Max) : -3.5dB / +4.5dB Check 2 warnings Set Cancel See details Select items y • Optimization will not be performed while a warning message is displayed. We recommend that you solve the problem and perform "Auto Setup" again. 1 Press jCursor n / k to select "Check xx warning(s)" and then press jENTER. Details of the warning message are displayed. If there are multiple warning messages, you can display the next message using jCursor h. 2 To return to the top result display, press jENTER again. ADDITIONAL INFORMATION APPENDIX English 21 En