Yamaha RXV1065 Owner's Manual - Page 70

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Problem The picture is disturbed. No sound. Only the center speaker outputs substantial sound. No sound is output from a specific speaker. Cause The video software is copy-protected. Remedy Troubleshooting See page Incorrect input or output cable connections. No appropriate input source has been selected. Speaker connections are not secure. The volume is turned down or muted. Signals this unit cannot reproduce are being input from a source component, such as a CD-ROM. The HDMI components connected to this unit do not support the HDCP copy protection standards. "Audio Output" in "HDMI" is set to "TV". A proper audio decoder is not selected. When a monaural source sound field program is applied, sound of all channels are output from the center speaker for some surround decoders. The playback component or speakers are not connected properly. Output from that speaker is disabled. The volume of that speaker is set to minimum in "Speaker Setup" in the "Setup" menu. This unit is in the straight decode mode. Sound may not be output from certain channels depending on input sources or sound field programs. The speaker is malfunction. Connect the cables properly. If the problem persists, the cables may be defective. Rotate the RINPUT selector (or press dInput selection key) to select the desired input source. Secure the connections. Turn up the volume. Display "Signal Info" in the Option menu and check the input signal format. If "No Signal" is displayed, check if the playback component is properly connected to this unit (or a proper input source is selected). If "___" is displayed, the input signal in that format cannot be reproduced by this unit. Connect HDMI components that support the HDCP copy protection standards. Set "Audio Output" (Function Setup → HDMI → Audio Output) to the other setting. Display the Option menu and set "Decoder Mode" to "Auto". Try another sound field program. Connect the cables properly. If the problem persists, the cables may be defective. Check the Speaker indicators on the front panel display. If the corresponding indicator is turned off, try the following. 1) Change the input source to another one. 2) With the selected sound field program, sound is not output from that speaker. Select another sound field program. 3) "None" may have been selected for that speaker on this unit. Display "Speaker Setup" in the "Setup" menu and enables output of that speaker. Display "Speaker Setup" in the "Setup" menu and adjust the volume (Manual Setup → Speaker Level). Press OSTRAIGHT (or gSTRAIGHT) to turn off the straight decode mode. Try another sound field program. Check the speaker indicators on the front panel display. If the corresponding indicator lights up, connect another speaker and check if sound is output. If sound is not output, this unit may be malfunction. 15 22 11 22 - 81 58 47 25 12, 15 6, 22, 25, 55 57 28 25 - APPENDIX English 67 En