Yamaha RXV1065 Owner's Manual - Page 79

Troubleshooting Error message E-7:NO MIC E-8:NO SIGNAL Cause The optimizer microphone was unplugged during the "Auto Setup" procedure. The optimizer microphone does not detect test tones. E-9:USER CANCEL E-10:INTERNAL ERROR "Auto Setup" was canceled due to an inappropriate user operation. An internal error occurred. After Auto Setup Remedy Do not touch the optimizer microphone during "Auto Setup". See page 19 Check whether the microphone is properly placed. Check whether the speakers are properly placed and connected. The optimizer microphone or OPTIMIZER MIC jack may be defective. Contact the nearest Yamaha dealer or service center. Run "Auto Setup" again. 19 10, 11 - 19 Run "Auto Setup" again. 19 Error message W-1:OUT OF PHASE W-2:OVER 24m (80ft) W-3:LEVEL ERROR W-4:CHECK PRNS Cause Remedy Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. Check the polarities (+, -) of the displayed speaker. If they are correct, the speakers work properly even when this message is displayed. The distance between the speaker and the Bring the speaker within 24 m (80 ft.) area around listening position is over 24 m (80 ft). the listening position. The difference of volume level among speakers is excessive. Recheck the speaker positions and make sure all speakers are placed in a similar environment. Check the polarities (+, -) of the speakers. We recommended that you use speakers with the same or similar specifications. Adjust the output volume of the subwoofer. Presence speakers were not detected during measurement with "Extra Speaker Assignment" set to "Presence". Check the presence speaker connections and perform measurement again. If presence speakers are not connected, set the "Extra Speaker Assignment" to other than "Presence". See page 12 - - 12 - - 11, 56 76 En