Yamaha RXV1065 Owner's Manual - Page 32

INTRODUCTION PREPARATION BASIC OPERATION FM/AM tuning The FM/AM tuner of this unit provides the following two modes for tuning. ■ Frequency tuning mode You can tune in to a desired FM/AM station by searching or specifying its frequency. ■ Preset tuning mode You can preset the frequencies of FM/AM stations by registering them to specific numbers, and later just select those numbers to tune in. Note • Adjust the FM/AM antennas connected to this unit for the best reception. Tuning in to the desired FM/AM station (Frequency tuning) 1 Rotate the RINPUT selector (or press dTUNER) to select "TUNER" as the input source. 2 Press GFM (eFM) or GAM (eAM) to select a band. "FM" or "AM" appears on the front panel display according to the band that you have selected. 3 Press HTUNING/CH l / h (or eTUN./CH k / n) to specify the frequency. To adjust the frequency to a higher range, press h (or k). To adjust it to the lower range, press l (or n). The TUNED indicator on the front panel display lights up when the tuner is tuned in to a station. The STEREO indicator also lights up if the program being broadcasted is in stereo. STEREO TUNED FM 92.5 MHz The frequency changes in the following manner according to how you press HTUNING/CH l / h (or eTUN./ CH k / n). When you press the key more than 1 second The tuner searches the frequency of a station that is detectable around the current frequency. This is effective when the tuner can receive strong signals without any interference. Once the search starts, release the key. When you keep holding the key, the search continues even when a station is detected. This is useful when you want to tune in to a specific station. When you press and release the key The tuner increases or decreases the frequency in steps. Use this method when the tuner cannot receive strong signals and stations are skipped during the search. y • You can switch between stereo and monaural for FM broadcast in the Option menu (page 48). • (U.S.A. model only) When tuning in to an HD Radio station, the HD indicator lights up. See page 31 for details about the HD Radio features. 4 To tune in by direct frequency tuning, press lNumeric keys to enter the frequency of the station. Enter only integers. For example, if you want to set the frequency to 88.9 MHz, enter "889". Notes • When you press lNumeric keys during preset tuning, a preset number is selected. Set tuning mode to frequency tuning mode using HTUNING/CH l / h (or eTUN./CH k / n) prior to the operation. • "Wrong Station!" appears on the front panel display when you enter a frequency that is out of receivable range. Make sure that the entered frequency is correct. Registering FM/AM stations and tuning in (Preset tuning) You can register up to 40 FM/AM stations (Preset). Registering stations by automatic station preset The tuner automatically detects FM stations with strong signals and registers up to 40 stations. To register AM stations, use manual station preset. (U.S.A. model only) You can register up to 40 FM HD Radio, AM HD Radio and analog FM radio stations with strong signals. Note • (U.S.A. model only) If you register an FM HD Radio station with this feature, only the main audio program of the station (HD1) will be stored. To store other audio program, preset the station manually. 1 Rotate the RINPUT selector (or press dTUNER) to select "TUNER" as the input source. 2 Press rOPTION on the remote control. The Option menu for "TUNER" is displayed (page 47). 3 Select "Auto Preset" and then press jENTER. Auto Preset Automatic station preset starts about 5 seconds later from the lowest frequency upwards. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 29 En