2013 Chrysler 200 Owner Manual Convertible - Page 19

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 authorized dealer or by using the Customer Key Pro- 2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at gramming procedure. This procedure consists of proleast three seconds, but no longer than 15 seconds. gramming a blank key to the vehicle electronics. A blank Then, turn the ignition switch to the LOCK position key is one which has never been programmed. and remove the first key. NOTE: When having the Sentry Key௡ Immobilizer System serviced, bring all vehicle keys with you to an 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position authorized dealer. within 15 seconds. After ten seconds, a chime will Customer Key Programming sound. In addition, the Vehicle Security Light will You can program new keys to the system if you have two begin to flash. Turn the ignition switch to the LOCK valid Sentry Keys௡ by performing the following proceposition and remove the second key. dure: 4. Insert a blank Sentry Key௡ into the ignition switch. 1. Cut the additional Sentry Key௡ Transponder blank(s) Turn the ignition switch to the ON/RUN position to match the ignition switch lock cylinder key code. within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the indicator light will turn on again for three seconds and then turn off. 2