2013 Chrysler 200 Owner Manual Convertible - Page 50

48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 6. To release the belt, push the red button on the buckle. 1. Position the latch plate as close as possible to the anchor point. The belt will automatically retract to its stowed position. If necessary, slide the latch plate down the 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, webbing to allow the belt to retract fully. grasp and twist the belt webbing 180° to create a fold that begins immediately above the latch plate. WARNING! The seat belts in the passenger seating positions are equipped with Automatic Locking Retractors (ALR) which are used to secure a child restraint system. For Lap/Shoulder Belt Untwisting Procedure additional information, refer to "Installing Child ReUse the following procedure to untwist a twisted lap/ straints Using The Vehicle Seat Belt" under the "Child shoulder belt. A frayed or torn belt could rip apart in a collision and leave you with no protection. Inspect the belt system periodically, checking for cuts, frays, or loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system. Seat belt assemblies must be replaced after a collision if they have been damaged (bent retractor, torn webbing, etc.). 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of the latch plate. 4. Continue to slide the latch plate up until it clears the folded webbing. Seat Belts In Passenger Seating Positions