2013 Chrysler 200 Owner Manual Convertible - Page 370

368 STARTING AND OPERATING will turn off. The vehicle may need to be driven for up to 1. Jamming due to electronic devices or driving next to facilities emitting the same Radio Frequencies as the 20 minutes above 15 mph (24 km/h) in order for the TPM sensors. TPMS to receive this information. Check TPMS Warning When a system fault is detected, a chime will sound and the "Tire Pressure Monitoring Telltale Light" will flash on 3. Lots of snow or ice around the wheels or wheel and off for 75 seconds and then remain on solid. In housings. addition, the EVIC will display a ЉCHECK TPM SYS4. Using tire chains on the vehicle. TEMЉ message for a minimum of five seconds and then display dashes (- -) in place of the pressure value to 5. Using wheels/tires not equipped with TPM sensors. indicate which sensor is not being received. The EVIC will also display a ЉCHECK TPM SYSTEMЉ If the ignition key is cycled, this sequence will repeat, message for a minimum of five seconds when a system providing the system fault still exists. If the system fault fault related to an incorrect sensor location fault is no longer exists, the "Tire Pressure Monitoring Telltale detected. In this case, the ЉCHECK TPM SYSTEMЉ mesLight" will no longer flash, and the ЉCHECK TPM sage is then followed with a graphic display with presSYSTEMЉ message will no longer display, and a pressure sure values still shown. This indicates that the pressure value will display in place of the dashes. A system fault values are still being received from the TPM sensors but can occur due to any of the following: they may not be located in the correct vehicle position. 2. Installing some form of aftermarket window tinting that affects radio wave signals.