2013 Chrysler 200 Owner Manual Convertible - Page 229

UNDERSTANDING YOUR INSTRUMENT PANEL 227 indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon If the vehicle diagnostic system detects a leak or change your personal driving style. in the evaporative system, or the fuel filler cap is loose, improperly installed, or damaged, the words "gASCAP" Unless reset, this message will continue to display each will display in the odometer display area. If this occurs, time you turn the ignition switch to the "ON" position. tighten the fuel filler cap properly and press the odom- To turn off the message temporarily, press and release the eter reset button to turn off the "gASCAP" message. Trip Odometer button on the instrument cluster. To reset (Refer to "Onboard Diagnostic System - OBDII" in the oil change indicator system (after performing the "Maintaining Your Vehicle" for further information). If scheduled maintenance) perform the following procethe problem continues, the message will appear the next dure: time the vehicle is started. See your authorized dealer Turn the ignition switch to the ON/RUN position (do not service center as soon as possible. start the engine). CHANgE OIL Fully depress the accelerator pedal slowly 3 times within Your vehicle is equipped with an engine oil change 10 seconds. indicator system. The "CHAngE OIL" message will flash in the instrument cluster odometer for approximately 12 Turn the ignition switch to the LOCK position. seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change gASCAP 4