2013 Chrysler 200 Owner Manual Convertible - Page 199

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 197 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink௡ button you wish to program while keeping the HomeLink௡ indicator light in view. 3. Simultaneously press and hold both the Homelink௡ button you want to program and the hand-held trans- Reprogramming A Single HomeLink௡ Button mitter button. To reprogram a channel that has been previously trained, follow these steps: 4. Continue to hold both buttons and observe the indicator light. The Homelink௡ indicator will flash slowly 1. Turn the ignition switch to the ON/RUN position. and then rapidly after HomeLink௡ has received the 2. Press and hold the desired HomeLink௡ button until frequency signal from the hand-held transmitter. Rethe indicator light begins to flash after 20 seconds. Do lease both buttons after the indicator light changes not release the button. from slow to rapid. 3. Without releasing the button proceed with "Program5. Press and hold the programmed HomeLink௡ button ming A Non-Rolling Code" Step 2 and follow all and observe the indicator light. remaining steps. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink௡ button is pressed. • To program the two remaining HomeLink௡ buttons, repeat each step for each remaining button. DO NOT erase the channels. 3