2013 Chrysler 200 Owner Manual Convertible - Page 230

228 UNDERSTANDING YOUR INSTRUMENT PANEL NOTE: If the indicator message illuminates when you To reset the trip odometer, first display the trip mileage start the vehicle, the oil change indicator system did not that you want to reset, "Trip A" or "Trip B." Then push reset. If necessary, repeat this procedure. and hold the button (approximately 2 seconds) until the display resets to 0 miles (kilometers). The odometer must For vehicles equipped with the Electronic Vehicle Inforbe in Trip Mode to reset the trip odometer. mation Center (EVIC), refer to "Electronic Vehicle Infor17. Electronic Throttle Control (ETC) Indicator Light mation Center (EVIC)". This light informs you of a problem with the Electronic Throttle Control (ETC) system. If a This indicator shows that the Electronic Speed problem is detected, the light will come on Control System is ON. while the engine is running. If the light remains 16. Odometer/Trip Odometer Reset Button lit with the engine running, your vehicle will usually be drivable and not need towing, however see your authoTrip Odometer rized dealer for service as soon as possible. Press and release this button to change the display from If the light is flashing when the engine is running you odometer to "Trip A." Press and release it a second time may experience power loss, an elevated/rough idle, and to change the display to "Trip B." Press and release it a increased brake pedal effort, and your vehicle may third time to change the display back to the odometer. require towing. Immediate service is required. 15. Cruise Indicator - If Equipped