2013 Chrysler 200 Owner Manual Convertible - Page 198

196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING" button. This can usually be found where the hanging antenna wire is attached to the garage door opener/device motor. Firmly press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. To program the remaining two HomeLink௡ buttons, repeat each step for each remaining button. DO NOT erase the channels. Reprogramming A Single HomeLink௡ Button To reprogram a channel that has been previously trained, follow these steps: 1. Turn the ignition switch to the ON/RUN position. NOTE: You have 30 seconds in which to initiate the next 2. Press and hold the desired HomeLink௡ button until step after the LEARN button has been pressed. the indicator light begins to flash after 20 seconds. Do not release the button. 6. Return to the vehicle and press the programmed HomeLink௡ button twice (holding the button for two 3. Without releasing the button proceed with "Programseconds each time). The EVIC will display "CHANming A Rolling Code" Step 2 and follow all remaining NEL # TRANSMIT". If the garage door opener/device steps. activates, programming is complete. Programming A Non-Rolling Code NOTE: If the garage door opener/device does not activate, press the button a third time (for two seconds) to For programming Garage Door Openers manufactured before 1995. complete the training.