AIWA NSX-V70 Operating Instructions - Page 20

2 W TUNING DOWN uPWf MONO MANUAL TUNING 1 Press the TUNEFUBAND button to select the band repeatedly. If the power is turned off, the previously tuned station will be played (Direct Play Function). n 2 Press the M DOWN or H UP button to select a station. Each time the button is pressed, the frequency changes. When a station is received, 'TUNE is displayed for 2 seconds. During FM stereo reception, ii(m)))is displayed. To search for a station quickly (Auto Search) Keep the W DOWN or FM UP button pressed. until the tuner starts searching for a station. After tuning in to a station, the search stops. To stop the Auto Search manually, press the M DOWN or M UP button. q The Auto Search may not stop at stations with very weak signals. When an FM stereo broadcast contains noise Press the MONO TUNER button to display "MONO" display. + u Noise is reduced, although reception is monaural. To restore stereo reception, press the button so that disappears. on the MONO To change the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval as follows. Press the POWER button while pressing the TUNER/BAND button. To reset the interval, repeat this procedure. q When the AM tuning interval is changed, all preset stations (see page 22) are cleared. The preset stations have to be set again. 20