AIWA NSX-V70 Operating Instructions - Page 54
Setting, The Sleep Timer
View all AIWA NSX-V70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
SETTING THE TIMER To cancel timer standby mode temporarily Press the TIMER button on the remote control so that @ or R~C disappears on the display. ~ restore the timer standby mode, press again to display 0 or REC Using the unit while the timer is set You can use the unit normally after setting the timer. Before turning off the power, repeat step 5 to prepare the source, and adjust the volume and tone. q Timer playback and timer recording will not begin unless the power is turned off. q Connected equipment cannot be turned on and off by the builtin timer of this unit. Use an external timer. TIMER RECORDING Timer recording is applicable for TUNER and VI DEO/AUX (with an external timer) sources only. Press the TIMER button twice on the remote control so that ~Cappears on the display, and press the II SET button within 4 seconds. Repeat the steps in page 52 from step 2 and insert the tape to be recorded into deck 2 after step 5. SETTING THE SLEEP TIMER The unit can be turned off automatically after a specified time passes. Use the remote control. 1 Press the SLEEP button. "SLEEP" @ lights up, and SLEEP seconds. @ is displayed for 4 2 Within 4 seconds, press the * or FP button to specify the time until the power is turned off. Each time the button is pressed, the time changes between 10 and 240 minutes in 10-minute steps. The specified time @is displayed. To check the time remaining until the power is turned off Press the SLEEP button once. The remaining time is displayed for 4 seconds. To cancel the sleep timer Press the SLEEP button twice so that "SLEEP disappears. on the display