Adaptec 5325301728 User Guide - Page 10

Replacing a Power Supply Assembly Snap Server 4200/4500 Series 3 Slide the cover off the rear of the server and set it aside. Caution There are static-sensitive electronics inside the server. Before you handle any parts, make sure you are working at a static-controlled workstation and that you are properly grounded. Replacing a Power Supply Enclosure 1 Remove the power supply clip. Grasp the plastic clip with your index finger and lift it out of the server. 2 Remove the old power supply. 3 Grasp the top of the power supply and pull it toward the rear of the server. Lift the power supply out of the server and set it aside. 4 Insert the new power supply Insert the replacement power supply into the server chassis and slide it forward into place. 2 Field Service Documentation Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of Adaptec or any of its subsidiaries.