Adaptec 5325301728 User Guide - Page 19

Installing a Serial ATA Card Snap Server 4200/4500 Series 2 Standing in front of the server, press down firmly on the cover with both hands, and push the cover backwards with a short, forceful thrust. Slide the cover off the rear of the server and set it aside. Remove the plastic PCI retention clip from the right rear corner of the server by lifting it out of the chassis. Back right corner of server (back view) 3 If a SCSI card is installed, remove the card and set it aside. Avoid contact with metal surfaces on the card. Installing the Serial ATA Card and Reinserting the SCSI Card Caution PCI cards are seated properly only when you hear a distinct 'snap' sound. 1 Remove the metal protective plate from the bottom PCI port opening by using your thumb to slide the plate towards the corner of the server and lifting it from the chassis. 2 Remove the Serial ATA card from its protective packaging. Avoid contact with metal surfaces on the card. 2 Field Service Documentation Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of Adaptec or any of its subsidiaries.