Adaptec 5325301728 User Guide - Page 23

Replacing a Serial ATA Card Snap Server 4200/4500 Series 2 The cover is seated tightly on the chassis. Standing in front of the server, press down firmly on the cover with both hands, and push the cover loose with a short, forceful thrust. 3 Slide the cover off the rear of the server and set it aside. Removing and Replacing the Serial ATA Card Caution PCI cards are seated properly only when you hear a distinct 'snap' sound. 1 Remove the PCI retention clip. The PCI retention clip is the plastic component located at the rear of the server. Lift the clip out of the server and set it aside. Back right corner of server (back view) 2 Remove the failed Serial ATA card from its slot. 3 Install the new Serial ATA card. 4 Replace the plastic PCI retention clip in the server chassis. Replacing the Top Cover Be sure to replace the top cover. Do not operate the server without the top cover in place. 1 Lower the top cover onto the server. 2 From the rear of the server, push the cover forward until it is firmly seated. 3 To secure the cover, tighten the screw at the rear of the server. 2 Field Service Documentation Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of Adaptec or any of its subsidiaries.