Adaptec 5325301728 User Guide - Page 20

Snap Server 4200/4500 Series Installing a Serial ATA Card 3 Install the Serial ATA card into the lower (PCIX) slot by grasping only the edges of the card and pressing firmly until it snaps into place. PCI PCIX PCI PCIX Back right corner of server (back view) 4 Do one of the following: • If reinserting the SCSl card to the upper (PCI) slot, grasp only the edges of the card and press firmly until it snaps into place. • If you do not have a SCSI card, be sure to replace the metal protective plate on the top PCI port. 5 Replace the plastic PCI retention clip in the server chassis. 6 Replace the top cover of the Snap Server by lowering it onto the server and pushing it forward until it is firmly seated. To secure the cover, tighten the screw at the rear of the server. Do not operate the Snap Server without the top cover in place. Field Service Documentation 3 Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of Adaptec or any of its subsidiaries.