Adaptec 5325301728 User Guide - Page 18
Installing a Serial ATA Card, Shutting Down the Server, Removing the Top Cover and SCSI Card
UPC - 753253017287
View all Adaptec 5325301728 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Snap Server 4200/4500 Installing a Serial ATA Card These instructions explain how to install a serial ATA card on the Snap Server 4500. The Serial ATA card must be installed into the lower Serial ATA slot of the Snap Server 4500. Shutting Down the Server Caution Shut down the server before you make any repairs. Improper shutdown may lead to loss of data or physical harm. 1 To start the shutdown process, press the power button on the front of the server. The green power LED remains lit until the shutdown process is complete. Do not disconnect the AC power cord while the LED remains lit. 2 After the power LED is off, disconnect the AC power cord and all other cables from the back of the server. 3 The server is heavy. With the help of an assistant, remove the server from the rack to a clean surface with ample room to the front and rear. Removing the Top Cover and SCSI Card 1 Remove the top cover of the Snap Server by turning the cover retention screw at the back of the server counterclockwise until it becomes loose. Field Service Documentation 1 Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent a commitment on the part of Adaptec or any of its subsidiaries.