Brother International BAS-311E Network Users Manual - English - Page 102
Error codes [E.9 *] - [E.F *], ages are present can result in severe injury.
View all Brother International BAS-311E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 6 Power supply and electrical parts adjustment s Error codes [E.9 *] - [E.F *] DANGER Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury. Code Cause Remedy E.90 E.91 E.A0 E.A1 E.c0 E.c1 E.c2 E.c3 E.c4 E.c5 Abnormal drop in power supply voltage, or power was turned on again immediately after it was turned off. Abnormal rise in power supply voltage. Starting switch was pressed without any valid sewing data loaded. Home position point was not detected within a certain time during home position detection. Motor PROM is not correctly inserted. The box cooling fan (at the left when looking from the front) is not operating. Heat shink of control circuit board is abnormally hot. Abnormal current detected in X pulse motor. dAbnormal current detected in X pulse motor. The box cooling fan (at the right when looking from the front) is not operating. Turn off the power and check the input voltage. After turning off the power, wait 3 seconds or more before turning it on again. Turn off the power and check the input voltage. Re-read the sewing data. Turn off the power and check the X-Y feed and the home position sensor connection. Turn off the power and check. Turn off the power and check whether any thread scraps have built up. Turn off the power and clean the air intake port of the box. Turn off the power and contact a qualified service technician. Turn off the power and contact a qualified service technician. Turn off the power and check whether any thread scraps have built up. E.d0 Air pressure drop error. Turn off the power and check. E.E0 Main PROM is not correctly inserted. Turn off the power and check. E.E1 E.E2 Communication error detected by control circuit board. Communication error detected by panel circuit board. Turn off the power, wait a while and then turn it back on. Turn off the power, wait a while and then turn it back on. E.E3 Bad connection in cable between panel and box. Turn off the power and check. E.F0 Power relay is not operating (malfunction of power supply circuit board). Turn off the power and contact a qualified service technician. E.F1 Bad connection in cable between power supply circuit board and main circuit board. Turn off the power and check. E.F2 Abnormal current detected in power supply circuit Turn off the power and contact a qualified service board. technician. REFERENCE segment LED alphabet Panel display Text display A b c d E F 6 H L O 94 BAS-311E.311EL.326E.326EL