Brother International BAS-311E Network Users Manual - English - Page 61
Adjusting the two-step work clamp lift amount, 1. Solenoid type
View all Brother International BAS-311E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Chapter 4. Adjustments 6. Adjusting the two-step work clamp lift amount ¡The maximum work clamp lift amount is 25 ± 1 mm (for solenoid type) or 30 ± 1 mm (for pneumatic type) from the top of the needle plate. ¡The lift amount for each model is adjusted as shown in the table at the time of shipment. type Solenoid type Pneumatic type Lift amount 20mm 20mm 6-1. Solenoid type e 20mm w q 1. Turn the power switch OFF. 2. Loosen the bolts w of work clamp arm lever F q. 3. Place a scale against the work clamp e, and then move work clamp arm lever F q up or down to adjust so that the amount of lift above the top of the needle plate is 20 mm. 4. After adjusting the lift amount (20 mm), tighten the bolts w of work clamp arm lever F q. BAS-311E.311EL.326E.326EL 53