Brother International BAS-311E Network Users Manual - English - Page 78

Chapter 5. How to make up the work clamp Chapter 5. How to make up the work clamp • The work clamp is available in two types; clamping type and cassette type. The maximum sewing range is (W × L) BAS-311E (130mm × 60mm), 311EL (220mm × 60mm), 326E (200mm × 100mm), 326EL (220mm × 100mm). s Clamping type s Cassette type Work clamp (separate plate) Work clamp (single type) Cassette clamp Cassette support Feed plate Cassette clamp assembly 1. How to make up clamping type work clamp Work clamp (Single type work clamp blank) s How to make up the work clamp Cut out the work clamp blank so that the cutout size is wider than the sewing position by (half of the presser foot diameter + 1 to 1.5 mm). D: diameter of the top end of the presser foot Sewing position (The needle threads along) Feed plate (Feed plate blank) D/2 + 1 to 1.5mm D/2 + 1 to 1.5mm Presser foot Work clamp 1 - 1.5mm D Feed plate Sewing position 1 - 1.5mm s How to make up the feed plate Cut out the feed plate blank 1 to 1.5 mm apart from the sewing position. In the case of the left figure, 1 to 1.5 mm margin is required on both sides of the sewing position. 1 - 1.5mm 1 - 1.5mm 1 - 1.5mm 70 BAS-311E.311EL.326E.326EL