Brother International BAS-311E Network Users Manual - English - Page 72
Adjusting the tension of the timing belt
View all Brother International BAS-311E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Chapter 4. Adjustments 12. Adjusting the tension of the timing belt Note: Be sure to check the home position after adjusting the tension of the timing belt. s Adjusting the tension of X-timing belt 311E 1. Remove the X-feed bracket cover q. 2. Loosen the bolt e of X-pulley base B w, then adjust the q tension using the bolt r. w t 9.8N(1kgf) 3mm 80mm e r y 3. Move the X-feed bracket y to the left end and apply a load of 9.8N (1 kgf) to the center of the X-timing belt B t. Then adjust the X-timing belt B t with the adjust bolt u to produce a deflection of 3 mm. u s Adjusting the tension of Y-timing belt 1. Remove the belt cover q and the frame side cover w. q e r t 64 w 2. Loosen the bolt r, and move the Y-feed pulse motor bracket e to adjust the tension of the Y-timing belt. 3. When the power of the machine is turned off, there should be no slack in the Y-timing belt y and the work clamp arm u should move back and forth easily. q Adjust the position of the Y-feed pulse motor bracket e using the bolt t. When the power is turned on, move the work clamp arm u u back and forth, and adjust the tension of the Y-timing belt y using the bolt t so that there is no looseness in the work clamp arm u. BAS-311E.311EL.326E.326EL