Brother International BAS-311E Network Users Manual - English - Page 98

Chapter 6 Power supply and electrical parts adjustment SW No. memo-3A memo-3B memo-3F Possible setting range Units 1-3 ---- ---- ---- Initial value Explanation 2 Change speed limit by stitch length. (Max. speed remains same) 1:Speed limit by stitch length is up,sewing speed increases. 2:Standard 3:Speed limit by stitch length is down, sewing speed decreases. * In case drifting problem occurs at a part of large stitch length, select 3. * If you select 1, Please be careful because drifting might Ï occur depending on sewing condition. 0 ---- 7. Checking the input sensor and DIP switch input t BAS-300E series POWER A ϓϩάϥϜ/0 PROGRAM NO. ϝχϡʔ MENU B.T. SET B.T. CHANGE u r ԣഒ཰ X-SCALE ॎഒ཰ Y-SCALE εϐʔυ SPEED B.T. COUNTER ಡॻ R / W q SPLIT N̤. B TEST STEP BACK e OFF OFF y\ w\ 1. When the SPLIT NO. indicator q is lit and the R/W switch e is pressed while the TEST switch w is being pressed, the X-SCALE indicator r will be lit and the state of the X home position signal will appear on the display t. s When sensor is ON s When sensor is OFF 2. Each time the MENU switch y is pressed, a different indicator will illuminate and the operating condition for the corresponding item will appear on the display. ¡When X-SCALE indicator is lit : X home position sensor ¡When Y-SCALE indicator is lit : Y home position sensor ¡When SPEED indicator is lit : Needle up signal (synchronizer) ¡When B.T. COUNTER indicator is lit : 24-split signal (synchronizer) ¡When SPLIT ON. indicator is lit : Needle down signal (synchronizer) 3. If the settings for DIP switch A at the side of the operation panel are changed at this time, the changed switch number will appear in the left digit of the PROGRAM NO. display u. 4. If the settings for DIP switch B are changed at this time, the changed switch number will appear in the right digit of the PROGRAM NO. display u. 90 BAS-311E.311EL.326E.326EL