Brother International BAS-311E Network Users Manual - English - Page 71
Y axis 326E, 326EL, with the work clamp.
View all Brother International BAS-311E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
s (Y axis) 326E, 326EL q w Chapter 4. Adjustments y u 0.1 - 0.5mm H - position (X = 0, Y = 0) r t e 1. Press the P key and adjust the Y-sensor setting plate e so that the needle q is aligned with the home position (X=0, Y=0) of the H-position standard plate w. 2. Press the P key again to make sure that the needle q is aligned with the home position (X=0, Y=0) of the H-position standard plate w. 3. Attach the Y-sensor setting plate e to the Y-home position bracket r using the bolt t. 4. Remove the needle q. 5. Press the P key to be out of the program mode, and turn off the power. 6. Replace the H-position standard plate w with the work clamp. Note: When adjusting the Y home position, be sure to set the clearance between the Y-driving shaft y and the surface where the sensor u is activated to 0.1 - 0.5 mm. If the clearance is too great, an error in home position detection may occur because the temperature of the sewing machine rises during sewing operation. BAS-311E.311EL.326E.326EL 63